Intro to electronics - build a sequencer

From Unallocated Space
Revision as of 12:10, 26 September 2011 by Eric (talk | contribs) (Created page with "This workshop is intended as an introduction to electronics as well as a hands on workshop where you will build your own sequencer. The inspiration for this comes from the DIY e...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This workshop is intended as an introduction to electronics as well as a hands on workshop where you will build your own sequencer. The inspiration for this comes from the DIY electronic music community. Special thanks goes to Rich Decibels for his outstanding keyquencer designs on which the project is based.

This workshop will span approximately 3 separate nights with a possibility for more as needed.

General outline

1st Session - General introduction to electronics

  Current Flow
  Resistors
  Capacitors
  Power supplies
  Breadboarding
  Integrated circuits
  Flashing LED
  Oscillator

2nd Session components of

  Bread board amp project
  Intro to soldering
  Solder amp project   
  Schmitt triggers
  Logic Gates
  Intro to simple Oscillator
  Breadboard simple Oscillator
  Design
   - circuit
   - physical

3rd Session

   Sequencer build
   Intro to Debugging