Intro to electronics - build a sequencer

From Unallocated Space
Revision as of 13:14, 26 September 2011 by Eric (talk | contribs)
Jump to navigation Jump to search

This workshop is intended as an introduction to electronics as well as a hands on workshop where you will build your own sequencer. The inspiration for this comes from the DIY electronic music community. Special thanks goes to Rich Decibels for his outstanding keyquencer designs on which the project is based.

This workshop will span approximately 3 separate nights with a possibility for more as needed.

General outline

1st Session - General introduction to electronics

  • Current Flow
  • Resistors
  • Capacitors
  • Power supplies
  • Breadboarding
  • Integrated circuits
  • Flashing LED
  • Oscillator

2nd Session

  • Bread board amp project
  • Intro to soldering
  • Solder amp project
  • Schmitt triggers
  • Logic Gates
  • Intro to simple Oscillator
  • Breadboard simple Oscillator
  • Design
    • circuit
    • physical

3rd Session

  • Sequencer build
  • Intro to Debugging
Retrieved from "https://www.wiki.unallocatedspace.org/wiki/index.php?title=Intro_to_electronics_-_build_a_sequencer&oldid=76"