Intro to electronics - build a sequencer: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
Line 12: | Line 12: | ||
*Breadboarding | *Breadboarding | ||
*Integrated circuits | *Integrated circuits | ||
* | *Bread board amp project | ||
*Oscillator | *Oscillator | ||
===2nd Session === | ===2nd Session Soldering, Oscillators and Sequencer=== | ||
*Intro to soldering | *Intro to soldering | ||
*Solder amp project | *Solder amp project | ||
Line 25: | Line 24: | ||
*Design | *Design | ||
**circuit | **circuit | ||
**physical | **physical - HOMEWORK!!! | ||
===3rd Session=== | ===3rd Session Sequencer Build=== | ||
*Sequencer build | *Sequencer build | ||
*Intro to Debugging | *Intro to Debugging | ||
*Sequencer fixing |
Revision as of 13:25, 26 September 2011
This workshop is intended as an introduction to electronics as well as a hands on workshop where you will build your own sequencer. The inspiration for this comes from the DIY electronic music community. Special thanks goes to Rich Decibels for his outstanding keyquencer designs on which the project is based.
This workshop will span approximately 3 separate nights with a possibility for more as needed.
General outline
1st Session - General introduction to electronics
- Current Flow
- Resistors
- Capacitors
- Power supplies
- Breadboarding
- Integrated circuits
- Bread board amp project
- Oscillator
2nd Session Soldering, Oscillators and Sequencer
- Intro to soldering
- Solder amp project
- Schmitt triggers
- Logic Gates
- Intro to simple Oscillator
- Breadboard simple Oscillator
- Design
- circuit
- physical - HOMEWORK!!!
3rd Session Sequencer Build
- Sequencer build
- Intro to Debugging
- Sequencer fixing