3D Printing: Difference between revisions
| Line 5: | Line 5: | ||
= Printers = | = Printers = | ||
== [[ | == [[3D Printers:Creality K1 Max|Creality K1 Max]] == | ||
[https://www.creality.com/products/creality-k1-max-3d-printer Manufacture Page] | [https://www.creality.com/products/creality-k1-max-3d-printer Manufacture Page] | ||
Revision as of 20:14, 12 May 2024
Unallocated Space has two main 3D printers set up for use. The Lulzbot Mini and Creality CR-10.
These are connected to a laptop with the Cura slicer software.
Printers
Creality K1 Max
Nozzle size: 4mm, 6mm Nozzle material: Brass plated wear resistant Hotend: Micro Swiss FlowTech
Filament size: 1.75mm Supported filamnet: ABS/PLA/PETG/PET/TPU/PA/ABS/ASA/PC PLA-CF/PA-CF/PET-CF
Build Volume: 300x300x300mm
Creality CR-10s
Filament size: 1.75mm Supported filament: PL/PETG/TPU/wood
Bed size: 300mm × 300mm × 400mm
Lulzbot Mini 1
Bed size: 152mm x 152mm x 158mm
Won in an essay contest.
Lulzbot Taz 3
Was missing power supply.
A new (low voltage) supply was purchased for it. We have a 360 volt but it originally used a 400v.
The power cable and housing is also missing. Bowie has found the part numbers for the connectors.
Legacy Printers
Common Problems
If you receive the following error message when launching Cura from Terminal, or nothing happens when you launch Cura through the GUI, do this:
Error message: /usr/share/cura-lulzbot/cura-lulzbot: /lib/x86_64-linux-gnu/libc.so.6: version `GLIBC_2.28' not found (required by /usr/share/cura-lulzbot/cura-lulzbot)
Solution: In terminal, run the command "sudo apt remove -y cura-lulzbot && sudo apt install -y cura-lulzbot=3.2.32" (without quotes) .
If you cannot save a profile in Cura, make sure you own all the files/directories in your home folder. We had this issue when someone ran it using sudo.
Solution: sudo chmod -R unallocatedspace:unallocatedspace ~/
Updates
To date we have had a total of 1 major purchase made to the project: the RAMPS DIY Kit I have created a parts list from McMaster Carr that I am verifying now. I should place the order this month.(January 2012) The project has received a total of $100 in cash donations.
1/19/2012 Total in Donations has gone up by $160 for a total of $260 donated to the project
- LulzBot Order #000499 - Hobbled Bolt
- MakerGear Order #5904 - Plastruder
- A2A Printer Order ID: 71 - Stepper Motors and Hardware kit
- UltiMachine Order #6446 - Heated Bed