3D Printing
Unallocated Space has two main 3D printers set up for use. The Creality K1 Max and Creality CR-10.
These are connected to a laptop with the Cura slicer software.
Printers
Creality K1 Max
Nozzle size: 4mm, 6mm
Nozzle material: Brass plated wear resistant
Hotend: Micro Swiss FlowTech
Filament size: 1.75mm
Supported filamnet: ABS/PLA/PETG/PET/TPU/PA/ABS/ASA/PC PLA-CF/PA-CF/PET-CF
Build Volume: 300x300x300mm
Creality CR-10s
Filament size: 1.75mm Supported filament: PL/PETG/TPU/wood
Bed size: 300mm × 300mm × 400mm
Lulzbot Mini 1
Bed size: 152mm x 152mm x 158mm
Won in an essay contest.
Legacy Printers
Common Problems
If you receive the following error message when launching Cura from Terminal, or nothing happens when you launch Cura through the GUI, do this:
Error message: /usr/share/cura-lulzbot/cura-lulzbot: /lib/x86_64-linux-gnu/libc.so.6: version `GLIBC_2.28' not found (required by /usr/share/cura-lulzbot/cura-lulzbot)
Solution: In terminal, run the command "sudo apt remove -y cura-lulzbot && sudo apt install -y cura-lulzbot=3.2.32" (without quotes) .
If you cannot save a profile in Cura, make sure you own all the files/directories in your home folder. We had this issue when someone ran it using sudo.
Solution: sudo chmod -R unallocatedspace:unallocatedspace ~/